During prints, the Z axis does not move and this causes the layers to print on top of one another. The nozzle ends up digging into previous layers. How to Fix Z-Wobble in 3D Printing? 1. Clean Rust from the Z-Axis Rail A rusty guide rail can cause unsmooth Z-axis movement and contribute to Z-wobble. To resolve this, you can use a rust remover and a dust-free cloth to clean the Z-axis rail. First, move the Z-axis to the highest point for easier cleaning. Z axis not moving during print. hi everyone, so I recently have set up my new 3d printer. I have set up my printer and it works, but whenever i print the print just piles filament until it begins to stick to the nozzle. i'm just hoping someone may have had this problem before and is offering a solution. I would test to see if your Z is moving backwards - with Z=0.3 I could see it was printing about half way up - if you move to z=10 it should move the bed down. Does it? I'm hoping it moves the bed up. If so then you can simply swap Z direction (several ways to do that) and swap the end stops. Problem: Z-Axis doesn't work during a print. It attempts to work, maybe climbs on the Z-Axis, but screws back down. It whines, too. But, Z-Axis DOES work while not printing. It doesn't matter if the bed and nozzle heating or not, if it's not printing, it works as it should. A 3D printer's Z, Y, or X-axis may stop moving due to loose nuts, inadequate lubrication, binding with the lead screw, a loose Z coupler, or faulty wiring. It can also occur due to a worn-out drive belt, a broken stepper motor, or a short circuit in the motherboard. R6Zv.

z axis not moving during print